| The method I used to securely
fix the fuse in the crate will only work if you have wing tubes in your
plane. If you don't you'll need to come up with an alternate method to
make sure the fuse can not move without putting undo stress on the
fuse.
The method I came up with is fastening two 2X4 wood
blocks together and drilling a slot in them the same size as the wing
tube. It should be a close fit, but does not have to be a tight fit. I was
only attempting to keep the plane from moving fore, aft, and upward. The
foam block under the landing gear kept the plane from moving down
and the rigid foam cradles keep the plane from moving side to side. The
hole is plenty deep so there is no pressure on the wing tube on the ends.
|
