| The second wing half is added on
top of the fuse in the same manner that the first one was packed on the
bottom. The wing is again held snuggly in the rigid foam, but not too tightly.
Rigid foam pieces are added to the top so it will
contact the crate lid when it is closed. It is only over points on either
side of the wing, not directly over the wing or fuse. This is done so if any
pressure is applied to the lid it will pass through to the bottom of the
crate without adding pressure to the wing or fuse.
You can also see the foam block I placed on the tip of
the spinner, but I don't think this was necessary.
|
